Flanged Pipe Elbow Adapter
A 70° pipe elbow designed in SolidWorks that connects two different flange standards in one part: a round flange on one end and a square flange on the other. The round flange has a Ø45 mm outer diameter and is mounted on a Ø30 mm pipe, with four Ø4 mm bolt holes equally spaced on a Ø37 mm bolt circle. The pipe follows a R50 mm bend through 70° and ends in a square flange of 40 × 40 mm with R4 rounded corners, four Ø4 mm bolt holes on a 32 × 32 mm pattern and a Ø20 mm central bore. Both flanges are 5 mm thick, and a small lug with a Ø6 mm hole (R6.25 mm boss) is added beside the square flange as a fixing point. The model was built from a sweep along the bend path, then the flanges, holes and lug were added as separate features. The dimensioned drawing shows the front, top and auxiliary views needed to manufacture the part. Where it is used: an adapter elbow like this changes the direction of flow and the connection type at the same time, so it removes the need for a separate elbow and a separate adapter. Typical uses are air, vacuum and fluid lines, pump and compressor outlets, small hydraulic and pneumatic manifolds, cooling circuits and ducting, wherever a round pipe connection must meet a square-flanged port in a tight space. Using one part instead of two means fewer joints, fewer possible leaks and a lighter, more compact assembly.